Of course you will have to have a kernel that is compiled with IPv6 support. Most modern Linux distributions already have this built in. You also have to have your IPv6 addresses handy. I use this simple web-based IPv6 calculator. With that tool select the IPv4 to IPv6 conversion and you should be good to go. So with everything in hand, you are ready to configure.

IPv6 support

First make sure your kernel supports IPv6. To do this you can first run the command:

sudo lsmod|less

and search the listing to see if ipv6 is there. If not try loading it with the command:

sudo /sbin/modprobe ipv6

Now issue the lsmod command to see if it is there. It should be.

Configuration

The file you want to configure will be the standard network interface configuration. Remember you are going to configure for static IP addresses. The file in question is /etc/network/interfaces. Most likely this is either not configured (if you are using DHCP) or set up for IPv4. We are going to blow that away now. We are also going to add something to this file that will ensure IPv6 is loaded properly and that your networking us making use of the new address scheme.

The details of our configuration:

IPv4 address: 192.168.1.10

IPv6 Address: 2002:c0a8:10a::

IPv4 gateway: 192.168.1.1

IPv6 gateway: 2002:c0a8:0101::

Now let’s add this to the /etc/network/interfaces file. The new file will look like this:

#IPV6 static configuration
iface eth0 inet6 static
pre-up modprobe ipv6
address 2002:c0a8:10a::
netmask 64
gateway 2002:c0a8:0101::


Notice the “pre-up” command. That is where we ensure that IPv6 is added to the kernel, otherwise you run the risk of attempting to use an IPv6 address in a system that is looking for an IPv4 address.

Now you will want to restart networking with the command:

/etc/init.d/networking restart

You should now have an IPv6 address enabled.

Testing

Before you assume everything is working, let’s make sure first. You can check your IP routing with the command:

ip -6 route show

The above command should return something like:

2002:c0a8:0100/64 dev eth0 proto kernel  scope  link src 2002:c0a8:10a

You can also check by pinging with the ping6 tool. A good IPv6 address to try is the Google address. Issue this command:

ping6 ipv6.google.com

If IPv6 isn’t working you will get error:

Network is unreachable

If IPv6 is working you will see the standard ping results in your terminal window.

Final thoughts

It’s only a matter of time before IPv6 is the defacto standard for network addressing. When that happens you do not want to be behind the curve or you’ll lose out fast. Make sure you know how to configure your Linux servers for IPv6 static addressing. You’ll be glad you do when the time comes.